Omni Basement Systems Before & After Photos

David & Debbie needed a full perimeter waterproofing job in their Hamilton Mountain house. 
they are ready to start to refinish the basement and don't want any amount of water to ruin their new finished basement

Omni Basement System installed WaterGuard which is a patented interior drainage system which drian to a SuperSump sump pump system. 

To control moisture, Omni installed Delta MS on the walls of the home. The Delta MS drains any moisture directly into the WaterGuard. 

Quite often the question comes up about waterproofing a basement bathroom with a perimeter drainage system. There was a shower stall in the way that needed to be removed but luckily, we could get behind the toilet without having to move it. 

Our masterful installer, Dustin, was able to jack hammer behind the toilet so that the WaterGuard drainage system could be installed. This way we are able to waterproof a basement bathroom. 

Matthew has a home with a nasty crawlspace in Hamilton, On. Keith from Omni Basement Systems met with Matthew and recommended the Cleanspace vapor barrier system to isolate the earth moisture from the home. 
The Cleanspace barrier is a 20mil thick, 7 layer lining. 

Matt has an old house in Hamilton. This house probably started as a just a crawlspace style and since it has had the basement lowered. This gives challenges to doing waterproofing. An interior waterproofing job is the only solution in this case. Omni Basement Systems, along with a P. Engineer designed a system that would waterproof this style of foundation.  
our Cleanspace wall membrane went on the wall and where there is a bench footing from the basement being lowered, Delta drainage membrane went over the footing to allow water to drain past into the WaterGuard interior drainage system. 

 Matt also needed support for his sagging floors so Omni Basement systems installed a fully galvanized supplemental beam and SmartJacks to support it. 

Matt in Hamilton had a crawlspace in Hamilton, On that needed a lot of help. As is with all crawlspaces, it needed encapsulation which is a vapor barrier over the ground to protect the house from the earth's moisture. The floors were already sagging because of the poor supports that it was sitting on. Omni Basement Systems went to work,. First cleaning the debris out and leveling the ground in order to install the Cleanspace vapor barrier. The next step was to install supplemental beams under the joist system and support them with our fully galvanized and adjustable Smartjacks system. these SmartJacks are designed to hold up to 30.000lbs. and will never rust.